How to make automatic door in minecraft with sculk sensor

1

Dig a two-by-two-by-three hole. This means that the hole should be two blocks deep, two blocks long, and three blocks wide.

2

Dig two wire channels. When facing a three-block-wide side, dig a two-block-tall, two-block long corridor from the middle block, then remove the top block in front of you.

How to make an automatic door in minecraft with button

3

Place redstone on the bottom of the hole. This will create a two-by-three grid of redstone.

4

Place a redstone torch at the end of each channel. This torch will go on the raised block at the end of each corridor.

5

Line the corridors with redstone. You'll place two redstone on the floor of each corridor to connect the redstone torches to the redstone on the floor of the hole.

6

7

Cover up the